Fast-Fix Emergency Tyre Repair Kit

Instructions:
1. Mark the position where the tire needs to be repaired and pull out the puncture.
2. Use the spiral cone to determine the direction of the wound, apply glue to the front of the spiral cone, and insert. Insert and pull out the wound more than three times to fill it with the vulcanizing agent.
3. Insert the tire repair rubber strip into the front port of the tire repair pin halfway on one side.
That is, all the patterns of the two sides of the vulcanized rubber strip, gluing, inserting, and inserting until the end.
4. Pull out slowly and stop when you pull out the rubber strip by 1 cm, when there are four rubber strips in the hole state.
5. Cut the rubber strip and leave it 2mm higher than the tread
. 6. Test with water. If there is air leakage, add another one along the edge as per 3 and 4.

Matters needing attention:
This tire repair tool is applicable to the repair of punctures smaller than 6mm from the nail hole of the vacuum tire. The tire pressure should be lower than 1.5 during repair, otherwise the film may easily rupture. Do not look directly at the wound hole during operation to avoid gas or foreign matter splashing out. Wear protective glasses during work.

Packing List:

1 Set: Tire Repair Kit * 1 Set
or
2 Set: Tire Repair Kit * 1 Set
Air Hose * 1
or
3 Set: Tire Repair Kit * 1
Glue * 1
Rubber Strip * 1
or
4 Set: Air Hose * 1